Simpson STC 18-Gauge Roof Truss Clips

• Model No.STC
• Measures. 1-1/4 x 1-7/8 x 2-3/4
• Gauge. 18
• Coating/Material. Zinc Galvanized, G90

Simpson roof truss clips are used for alignment control between a roof truss and nonbearing walls the 1-1/2″ openingspermits vertical truss chord movement when a load is applied.

Installation

• Install with 8d common nails
• Use STC or DTC depending on required loads. STC, installed with DS drywall stop, helps prevent fasteners tearing through the ceiling drywall (see installation illustration).
• Use STCT where truss or rafter is separated from the top plate of the nonbearing wall.
• Install slot nails in the middle of the slot.
• Products not intended for floor applications due to the frequency of floor joist deflections and potential for squeaks.