Simpson 7" Beam Column Cap CCO7 1/8

The CCO is designed to provide strong column-beam connections on top of steel columns. The column cap features a design without legs enabling a field-welded attachment to steel columns and posts. The seat of the column cap provides additional surface area for bearing that extends beyond each side of the column. This helps to distribute the load from the beam and provide support for the connection.

• Model No. CCO7 1/8
• Beam Width (in.) 7
• Length (in.) 13
• Height (in.) 8
• Material. 3 gauge
• Finish. No Coating

Key Features

• Uplift loads increased for earthquake or wind loading
• Bolt spacing that meets NDS code requirements to ensure optimal performance
• Diamond holes to provide temporary fastening

This is a Special order or Made to order product by Simpson Strong-Tie. It is non-refundable with varied lead times. Please verify that all configurations / specifications are correct before checking out.

Options

• Contact us for Configurable Options and Special orders
• For special, custom or rough-cut lumber sizes, provide dimensions.
• CCO may be ordered for field welding to pipe or other columns. Weld by designer.
• See CCO Column Cap Load Table. See Table
• See CCO Column Product Guide. See SPECS

Installation

• Use all specified fasteners; see General Notes
• Weld by designer
• Bolt holes shall be a minimum of 1/32″ to a maximum of 1/16″ larger than the bolt diameter (per 2018 NDS, section 12.1.3.2); bolt holes should be drilled from one side all the way through the beam to maintain hole tolerances
• Contact engineered wood manufacturers for connections that are not through the wide face

Note: Product dimensions and/or Screw or Bolt holes may differ from picture. Please see item description for specifications.